Download Dell E770S - 17" CRT Display Quick Setup Manual for Free
Download Monitor Instruction Manual of Dell E770s for free from ManualsDB.
Dell E770s Color Monitor Quick Setup Guide Safety Instructions Observe the following safety guidelines when connecting and using your monitor. • • • • • • • • • • • Be sure your monitor is electrically rated to operate with the AC power available in your location. Locate your monitor near an easily accessible electrical outlet. Place the monitor on a solid surface and treat it carefully. The screen can be damaged if dropped, sharply hit, or touched with a sharp or abrasive implement. Put your monitor in a location with low humidity and a minimum of dust. Never use your monitor if the power cable has been damaged. Do not allow anything to rest on the power cable, and keep the cable away from where people could trip over it. Never insert anything metallic into the monitor openings. Doing so may create the danger of electric shock. To avoid electric shock, never touch the inside of the monitor. Only a qualified technician should open the monitor's case. Be sure to hold the plug, not the cable, when disconnecting the monitor from an electrical outlet. Openings in the monitor cabinet are provided for ventilation. To prevent overheating, these openings should not be blocked or covered. Also, avoid using the monitor on a bed, sofa, rug, or other soft surface. Doing so may block the ventilation openings in the bottom of the cabinet. If you put the monitor in a bookcase or some other enclosed space, be sure to provide adequate ventilation. Do not expose the monitor to rain or use it near water. If the monitor accidentally gets wet, unplug it and contact an authorized dealer immediately. You can clean the exterior of the monitor with a damp cloth when necessary, but be sure to unplug the monitor first. If your monitor does not operate normally - in particular, if there are any unusual sounds or smells coming from it - unplug the monitor immediately and contact an authorized dealer or service center. Connecting Your Monitor to a Computer 1. 2. 3. 4. 5. Turn off your computer and unplug your computer's power cable. Connect the blue connector of the monitor's signal cable to the blue video connector on the back of your computer. Tighten the connector screws finger-tight. Do not over tighten. Fully insert the monitor power cable into the power port on the back of the monitor. Plug the power cables of your computer and your monitor into a nearby electrical outlet. Turn on your computer and monitor. If the monitor does not display an image, refer to the troubleshooting section of this guide. Dell E770s Color Monitor Quick Setup Guide Downloaded from www.manualsdb.com manuals search engine 1 Monitor Controls and Indicators 1 EXIT button 2,3 -/+ buttons 4 MENU button Power Indicator Power button 5 6 This button closes the on-screen display (OSD). If the current OSD shows a sub-menu, this button returns the previous OSD. NOTE: Holding in the EXIT button for longer than 5 seconds erases all data in the User Settings memory. These buttons allow you to select and adjust items using the on-screen display. When adjusting an item using the OSD, the - (minus) button lowers the value of the selected function. The + (plus) button raises the value of the selected function. These buttons are also used as direct access buttons for the Contrast and Brightness feature controls. This button is used With the OSD system to activate a highlighted function for adjustment. This light glows green during normal operation. Use this button to turn the monitor on and off. Driver Installation Use the monitor CD to install the appropriate monitor drive for your operating system. Microsoft Windows 98 Operating System Windows 98 automatically detects the new monitor and displays the Add New Hardware Wizard dialog box if the monitor driver is not already installed. 1. Insert the monitor CD into the CD-ROM drive, and click Next> twice when the Add New Hardware Wizard dialog box appears. 2. Click the CD-ROM drive box to install the drivers from the CD and then click Next>. 3. Confirm that the driver was found on the CD, and click Next> twice to install the driver. 4. Click Finish to exit the Add New Hardware Wizard dialog box. To manually install or update the driver, perform the following steps: 1. Click Start Settings Control Panel and then double-click Display. 2. In the Display Properties window, click the Settings tab, and then click Advanced. 3. Click the Monitor tab, and then click Change. 4. When the Update Device Driver Wizard dialog box appears, follow the steps in the previous paragraph. Microsoft Windows 95 Operating System First determine the Windows 95 version installed on your computer by right- clicking the My Computer icon on the desktop and selecting Properties. The version number is listed under System. Perform the steps for the appropriate version. Version 4.00.950A 1. 2. 3. 4. 7. Click Start Settings Control Panel and then double-click Display. In the Display Properties window, click the Settings tab, and then click Change Display Type. In the Change Display Type window, click Change and then click Have Disk. Insert the monitor CD into the CD-ROM drive, type d:\ (change the drive letter to match your CD-ROM drive if it is not drive D) in the Copy manufacture's files from: box, and click OK. In the Select Device window, click the appropriate monitor model and then click OK. In the Change Display Type window, click Close. In the Display Properties window, click OK. 2 Dell E770s Color Monitor Quick Setup Guide 5. 6. Downloaded from www.manualsdb.com manuals search engine Version 4.00.950B 1. 2. 3. 4. 5. 6. 7. 8. Click Start Settings Control Panel and then double-click Display. In the Display Properties window, click the Settings tab, and then click Advanced Properties. In the Advanced Display Properties window, click the Monitor and then click Change. In the Select Device window, click Have Disk. Insert the monitor CD into the CD-ROM drive, type d:\ (change the drive letter to match your CD-ROM drive if it is not drive D) in the Copy manufacture's files from: box, and click OK. In the Select Device window, click the appropriate monitor model and then click OK. In the Change Display Type window, click Close. In the Display Properties window, click OK. Accessing the User's Guide Online or via CD. To view the latest monitor User's Guide, access the SUPPORT section of the Dell Web Site (http://support.dell.com). if you do not have internet access the guide on the monitor CD 1. 2. Insert the monitor CD into your CD-ROM drive. A start-up document should launch automatically; however, if the start-up document does not launch automatically, click Start--> Run, type D:\monitor.htm, and click OK.(Substitute the correct CD-ROM drive letter if it is not the D drive) Click the appropriate icon to open the User's Guide in the desired language. NOTE: All applicable warranty and regulatory information regarding your monitor is contained in the User's Guide on your CD. Troubleshooting Tips Monitor Has No Power If the monitor's power indicator is off and no image appears on the display, perform the following checks: • Ensure that the power cable is fully inserted in the monitor's power port and the electrical outlet. • Test the electrical outlet by plugging in a working electrical device such as a lamp. • Ensure that the power button has been depressed, and wait for the power indicator to light. • Try another power cable on the monitor. Use the computer's power cable and turn monitor with the signal cable disconnected. If the monitor is working correctly, a self-test pattern appears. No Image Is Displayed on the Monitor If the monitor power indicator is on but no image appears on the display, perform the following checks: • Ensure that the video connector is seated properly. Tighten the connector screws securely with your fingers. • Ensure that the computer is on. • Increase brightness and contrast controls. • Turn off the monitor and unplug the signal cable. Check the cable connector for bent or broken pins. • With the signal cable still disconnected, turn on the monitor. If the Monitor is working correctly, a selftest pattern appears. • Perform a monitor reset or recall. Dell E770s Color Monitor Quick Setup Guide Downloaded from www.manualsdb.com manuals search engine 3 IMPORTANT! Before contacting Dell for technical assistance, refer to the Troubleshooting section in the User's Guide on your monitor CD. This section contains detailed information for resolving most monitor problems. Information in this document is subject to change without notice. 1999 Dell Computer Corporation. All rights reserved. Reproduction in any manner whatever without the written permission of Dell Computer Corporation is strictly forbidden. Trademarks used in this text: Dell and the DELL log are trademarks of Dell Computer Corporation; Microsoft and Windows are registered trademarks of Microsoft Corporation. Other trademarks and trade names may be used in this document to refer to either the entity claiming the marks and names or their products. Dell Computer Corporation disclaims any proprietary interest in trademarks and trade names other than its own. December 1999 4 P/N 2010V, 3010V Rev. A00 Dell E770s Color Monitor Quick Setup Guide Downloaded from www.manualsdb.com manuals search engine